Cassie Decker Sailboat February 08th, 2018 - 10:30:25
Most importantly, remember where the washers and other little items go in the winch. Its hard to figure out their location. Dont waste time worrying about the larger winch gears and drive shaft. Its easy to find their homes. Pulling the gears and bearings out is actually quite simple and doesnt require any sailboat winch tools or skill. They just slip over the gear shaft. Cleaning the Sailboat Winch Components Place gears and bearings in the small can. Add the mineral spirits to the can and allow to soak. Take the gears and bearings and place them in a small can. Cover the parts with mineral spirits and soak.
If you choose to build your own sailboat you must first decide on the size you want. There are several practical considerations that you must keep in mind. These include the stretch of water where you will sail your boat, how you plan to transport it, and, if you are not so strong, how you will launch and recover it. There are several ways to go about building your own RC Sailboat. The simplest is to buy a kit at a hobby store, build it up, and finish it off with a different colour scheme or other detail. This is a good way to start because you gain useful experience. If this does not satisfy you then you ought to consider scratch building your own.
Most sailboats are fiberglass these days, but if you are looking for a really strong sailboat, you are likely to choose steel or aluminum. Fiberglass is fine for normal use, but if you are going cross oceans, or give your sailboat a hard life, metal is best. They are also good materials if you want to get your own design of sailboat built. The reason aluminum or steel are best is that metals are both strong and stiff, and when hit really hard, they bend - fiberglass and even the most advanced composites will break, and even shatter. Then the sailboat will almost certainly sink. A sailboat with a dent in the hull can keep going.
Disassembly of Sailboat Winch To disassemble, remove the drum from the base of the winch using the screw at the bottom of the winch handle socket. Simply unscrew it, pull the socket out, and the drum will lift off. As you lift the drum, be aware the winch roller bearing cages may momentarily stick inside the drum and could unexpectedly drop out. Make sure they dont bounce off the deck into the water. Now you can remove all the winch gears and bearings for cleaning. Even though the sailboat winch only goes back together one way, it wont hurt to take a good look at everything.