Trisha Flores Sailboat February 11th, 2018 - 16:07:09
Some people called the wooden sailboats as the older sailboats, because it is made out of wood. This can be very beautiful, particularly when properly maintained. With the right woods, a sailboat can be lovely to look at. However, there are plenty of problems associated with woods. This is the advantages of wooden sailboats, even treated wood will tend to rot away over time and it is something that also attracts insects and pests, both air and waterborne, which will destroy the wood. The advantages of wooden sailboat, for some this may be here nor there, but a wooden sailboat is more attractive. The shine of teak wood shimmering against water is an age old sight that invokes thoughts of freedom and the sea. Fiberglass, while more easily colored, does not bring the same traditional beauty of sailing.
Disassembly of Sailboat Winch To disassemble, remove the drum from the base of the winch using the screw at the bottom of the winch handle socket. Simply unscrew it, pull the socket out, and the drum will lift off. As you lift the drum, be aware the winch roller bearing cages may momentarily stick inside the drum and could unexpectedly drop out. Make sure they dont bounce off the deck into the water. Now you can remove all the winch gears and bearings for cleaning. Even though the sailboat winch only goes back together one way, it wont hurt to take a good look at everything.
Although your RC Sailboat may be small enough to fit into your hand, or so large as to require a trailer to transport it, all radio control model sailboats are built in the same order as full size boats. The first stage is to form the hull, which must have space in it to accommodate the servo motors, batteries, and other gear. After float testing to determine the optimum position for the keel, you complete the hull by installing the controls that will allow you control the model sailboat remotely. Thereafter you fit the masts and spars, and install the sails and rigging.
After soaking, take the small brush and work off any old grease from the winch component. Dont forget to clean the winch gear ring on the inside of the drum. Now that youve removed the grease and grime, rinse the parts in hot water to remove the mineral spirits. If the spirits are left on, it breaks down the grease. Dry the parts with a clean rag or paper towel. Reassembly of Sailboat Winch As you put the gears back into place, take a close look at how the pawls are working. If they dont open and close smoothly, then the drum could spin backwards. If theres any question that the pawls are not working properly, it is much easier to replace them and the little springs. It is very important NOT to grease the pawls because grease causes them to stick. And if they stick, the gears wont engage. To lubricate your pawls, use any light oil that might be on hand; something like a 3 & 1 oil.